Roberts Gorden MGB Series Manual de servicio descargar pdf (Pagina 57)

SECTION 12: SERVICING

51 of 85

SECTION 12: SERVICING

12.1 Servicing Instructions

After commissioning, the heater will require

maintenance to be carried out annually. If the heater

is used in a dirty or dusty area, more frequent

maintenance may be necessary.

Installation, Service and Annual Inspection of the

heater must be done by a contractor qualified

in the installation and service of gas or oil-fired

heating equipment.

NOTE 1: After any maintenance or repair work,

always test fire the heater in accordance with the

commissioning instructions on Page 40, Section 10

through Page 47, Section 10.11 to ensure all safety

systems are in working order before leav ing the

heater to operate. Minor faults may be traced by

using the troubleshooting charts on Page 56,

Section 14 through Page 62, Section 14.7.

NOTE 2: Check all fuel pipes and pipe joints to

ensure there are no cracks or gas leaks. Any cracks

in the pipes or pipe joints must be repaired.

NOTE 3: Inspect all suspended components and

hardware. Insure that they are in good condition,

properly tightened, and corrosion free.

12.2 Burner Maintenance

1. See the manufacturer’s information for specific

instructions.

2. Clean the fan (and fuel filters, when fitted).

Inspect all components, including the flame

monitoring and ignition system, and correct

operation of fuel control valves.

Falling Hazard

Use proper safety

equipment and practices to

avoid falling.

Do not use any part of

equipment as support.

WARNING

Failure to follow these instructions can result in death, injury or property damage.

Burn Hazard

Allow equipment to cool

before service.

Internal components of

equipment may still be hot

after operation.

Explosion Hazard

Leak test all components of

equipment gas piping

before operation.

Gas can leak if piping is not

installed properly.

Do not high pressure test

gas piping with equipment

connected.

Electrical Shock Hazard

Disconnect electric before service.

More than one disconnect switch may be

required to disconnect electric from

equipment.

Equipment must be properly grounded.

Severe Injury Hazard

Do not enter equipment while in operation.

Equipment may start automatically.

Do not operate with door open.

Installation, operation and service must be

done by a trained technician only.

DANGER

Failure to follow these instructions can result in death, electrical shock or injury.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 91 92

Comentarios a estos manuales

Sin comentarios

Roberts Gorden MGB Series Manual de servicio Pagina 57

Comentarios a estos manuales