Roberts Gorden MGB Series Manual de servicio descargar pdf (Pagina 46)

COMBAT

CABINET HEATERS INSTALLATION, COMMISSIONING, OPERATION AND SERVICE MANUAL

40 of 85

SECTION 10: COMMISSIONING

Gas/Oil Fired Heater

Installation Code and Annual Inspections:

All installation and service of ROBERTS GORDON

equipment must be performed by a contractor

qualified in the installation and service of equipment

sold and supplied by Roberts-Gordon Europe

Limited and conform to all requirements set forth in

the ROBERTS GORDON

manuals and all

applicable governmental authorities pertaining to the

installation, service, operation and labeling of the

equipment. To help facilitate optimum performance

and safety, Roberts-Gordon Europe Limited

recommends that a qualified contractor conduct, at

a minimum, annual inspections of your ROBERTS

GORDON

equipment and perform service where

necessary, using only replacement parts sold and

supplied by Roberts-Gordon Europe Limited.

Read this manual carefully before installation,

commissioning, operation, or service of this

equipment. All components are accessed via the

louvered access panel below the burner. Opening

the door exposes live electrical connections and hot

components.

10.1 Pre-Commission Checks

These instructions should be read in conjuction with

the burner manufactuer’s manual.

All pre-commission checks must be carried out

before firing the heater.

Ensure that the heater and all controls are suitable

for the fuel, pressure and electrical supply to which

they are to be connected.

Electrical Shock Hazard

Disconnect electric before service.

More than one disconnect switch may be

required to disconnect electric from

equipment.

Equipment must be properly grounded.

Severe Injury Hazard

Do not enter equipment while in operation.

Equipment may start automatically.

Do not operate with door open.

Installation, operation and service must be

done by a trained technician only.

DANGER

Failure to follow these instructions can result in death, electrical shock or injury.

Falling Hazard

Use proper safety

equipment and practices to

avoid falling.

Do not use any part of

equipment as support.

WARNING

Failure to follow these instructions can result in death, injury or property damage.

Burn Hazard

Allow equipment to cool

before service.

Internal components of

equipment may still be hot

after operation.

Explosion Hazard

Leak test all components of

equipment gas piping

before operation.

Gas can leak if piping is not

installed properly.

Do not high pressure test

gas piping with equipment

connected.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 91 92

Comentarios a estos manuales

Sin comentarios

Roberts Gorden MGB Series Manual de servicio Pagina 46

Comentarios a estos manuales